Falcon 1000 Deluxe User's Guide download pdf (Page 16)

ArtNo.311-0029 - Burner base & head alignment

ArtNo.311-0030 - Burner head fitting

ArtNo.311-0028 - Burner head off

ArtNo.311-0028 - Flame

Fig.5-1

Fig.5-2

Fig.5-3

5. Cleaning Your Cooker

Essential Information

Isolate the electricity supply before carrying out any

thorough cleaning. Allow the cooker to cool.



NEVER use paint solvents, washing soda, caustic

cleaners, biological powders, bleach, chlorine based

bleach cleaners, coarse abrasives or salt.



DO NOT mix dierent cleaning products – they may

react together with hazardous results.

All parts of the cooker can be cleaned with hot soapy water

– but take care that no surplus water seeps into the

appliance.

Remember to switch on the electricity supply before re-using

the cooker.

Daily Care

Cleaning the cooker is not a welcomed chore, but it has to be

done to maintain eciency and appearance. Remember it

is better to wipe up any spills as they occur, this will prevent

them burning on and becoming more dicult to remove

later.



Make sure the ow of combustion and ventilation

air to the cooker is unobstructed – for example by

build-up of fats or grease.

On Natural Gas the burners ames should be a bluish colour

with, at most, a slight yellowish fringe.

On LP gas the ames may be “softer”. The cooktop burner

ames may have a slight yellowish tip.

If the ame burns with a long white tip you should call for

service.

Cleaning for Spills

For spills and boil-overs that occur while cooking, as soon as

possible turn o the burner and allow to cool. Do not clean

until the area is completely cooled down. Wipe up spills as

soon as possible.

Do not allow surplus water to seep into the cooker.

Cooktop Burners

The burner heads and caps can be removed for cleaning.



DO NOT put the burner heads in a dishwasher.

Make sure they are absolutely dry before replacing (Fig.5-1).

When replacing a burner head, make sure that it locates

properly within the base (Fig.5-2). If you look at the bottom

of the burner head you will see two ‘pips’ – these t into the

two notches in the burner base (Fig.5-3).

Check the burner ports are not blocked. If a blockage occurs,

remove stubborn particles using a piece of fuse wire.

A – Cap, B – Base

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

Comments to this Manuals

No comments

Falcon 1000 Deluxe User's Guide Page 16

Comments to this Manuals

Related products and manuals for Cookers Falcon 1000 Deluxe